Home / Blog / 3D printed intake

Can you 3D print an intake?

Parts of one, yes. The cool-air side of an intake is mostly shaped tubes and boxes, which is what a printer is good at. The catch is the heat under the hood, and that decides the plastic.

Prints wellducts, lids, stacks
Doesn'tboost-side parts
Plasticnylon CF or ASA
NeverPLA

Part by part

PartPrintable?Notes
Fresh-air duct or scoopYesFeeds outside air from the bumper or grille to the airbox. It sits at the front, away from the engine, so it's the easiest intake part to print.
Snorkel or airbox inletYesA good fit for printing when the stock one is cracked or no longer sold.
Airbox lid or filter adapterYesLets a cone or panel filter fit a box it wasn't made for. Needs a good seal at the filter.
Velocity stackYesThe flared trumpet on a throttle body or carb. The smooth bell shape is hard to make any other way at home.
MAF sensor housingWith careThe inside diameter changes what the sensor reads. Copy the stock bore exactly or the engine will need a tune.
Intake pipe after a turboNot in hobby plasticPressure plus heat. Layers can split under boost.
Intake manifoldSpecialist jobHeat, vacuum, fuel and vibration at once. Race teams print them in industrial nylon on industrial machines. A desktop print is a prototype for checking fit.

Heat decides the plastic

An engine bay runs far hotter than a car's cabin, and it stays hot after you switch off, when no air is moving. Plastics that are fine on a dashboard go soft here.

PlasticUnder the hood
Carbon fibre nylonThe usual choice. Stays stiff when hot and resists oil and fuel vapour. Has to be printed dry and on a hardened nozzle.
ASAWorks for ducting at the front of the bay, away from the exhaust and turbo. Handles sun and rain.
PETGMarginal. Fine for a duct behind the bumper, too soft near the engine.
PLANo. It will sag on the first hot day.

The same ranking for parts inside the car is in PLA vs PETG vs ASA in a hot car.

Where printed intakes fail

  • Wrong plastic. Most failures are a PLA or PETG part that softened and collapsed.
  • Leaks after the sensor. Any air that gets in after the airflow sensor isn't measured, and the engine runs lean. Joints need a proper seal, and the walls need enough layers to be airtight.
  • Loose bits. Stringing, support scraps and sanding dust on the inside of a pipe end up in the engine. The inside has to be cleaned and the part should sit before the filter where possible.
  • Hot air. A cone filter with no box pulls in engine-bay air, which is hotter than what the stock airbox was drawing. A printed duct or shield to feed it outside air matters more than the pipe.

What it's good for

A printed intake part doesn't add power by being printed. What printing gives you is a shape nobody sells: a duct that snakes round your radiator support, an adapter between a filter and an airbox that were never meant to meet, a replacement for a snorkel that's been out of production for twenty years. Whether it changes how the car runs depends on the car and has to be measured.

Check your state's emissions rules before changing intake parts on a road car.

Getting one made

Send photos of the engine bay with a ruler in the shot, the car's year, model and engine, and what you want the part to do. Ducts and adapters are drawn to fit the car and test-fitted in cheap plastic before the final part is printed. More on how one-off car parts get made is on the 3D printed car parts page.