Home / Services / 3D design and CAD

3D design and CAD in Orlando

Most people who need a part printed don't have a file for it. They have a broken piece, a sketch on a napkin, or an idea. The drawing is the first half of the job, and it's done here before anything is printed.

Start froma sketch, photos or the part
Priceagreed before work starts
Drawn and printed inWinter Park, FL
Filekept for reprints

What you can start from

You haveWhat happens
A broken partIt's measured with calipers and redrawn. Weak spots get made thicker than the original. This is reverse engineering, and it's the most common job.
Photos and a rulerSimple parts can be drawn from photos taken straight on with a ruler in the shot. You get asked for any measurement that can't be read off the photo.
A sketch with dimensionsHand-drawn is fine. Hole sizes, overall length, width and height, and what it attaches to.
An ideaSay what it has to do and where it goes. You get a drawing to approve before it's printed.
A file that won't printDownloaded models with holes, thin walls or the wrong size get repaired or redrawn.

How it goes

  1. Send what you have through the quote form.
  2. You get one price covering the drawing and the first print.
  3. The part is drawn. For anything that has to fit something else, you see a picture of the model with its dimensions before it's printed.
  4. It's printed and checked against the measurements. If the first one is a hair off, adjusting it is part of the job.
  5. Delivered around Orlando and Winter Park, picked up by appointment, or shipped.

What gets drawn here most

  • Replacement parts nobody sells: appliance knobs, pool and lanai clips, car trim, boat fittings. More on the replacement parts page.
  • Car parts made for one car: mounts, gauge pods, cupholder inserts. See 3D printed car parts in Orlando.
  • Prototypes for a product idea, with changes between rounds. See rapid prototyping.
  • Brackets, jigs and adapters that join two things never meant to meet.

What's not done here

There's no 3D scanner in the shop. Mechanical parts with flat faces, holes and straight edges are drawn more accurately from caliper measurements than from a scan. Sculpted, organic shapes that need scanning get referred to a shop that has one. Safety parts for cars, such as brake, steering and seat belt components, aren't drawn or printed.