Who this is for
Product engineers who need a physical check between CAD reviews. Hardware startups heading toward a pilot run. Inventors who have a sketch and need to see if the idea survives contact with reality. Students and researchers around UCF who need lab fixtures and test rigs this week, not after a purchase order clears.
Design notes that save a revision
- Walls: 1.2 mm minimum for small parts, 2 mm or more for anything that takes load.
- Holes: printed holes come out slightly undersized. Model screw holes about 0.2 mm larger, or ask for them to be drilled to size.
- Snap fits: orient the flexing arm along the layers. Across the layers, it snaps off.
- Overhangs: anything steeper than about 45° needs supports, which leave marks. Chamfers instead of flat ceilings avoid them.
- Threads: fine threads print poorly. Use heat-set brass inserts, which can be installed for you.
When to stop prototyping and tool up
Once the design stops changing and you need thousands a year, injection molding usually wins on unit cost. Until then, printing lets you keep changing your mind cheaply. And for 10 to a few hundred units, printing often stays the cheaper path. See production runs.