The formula
Each piece, in plain words
Shell. A printed part is mostly solid outer walls with a lighter lattice inside. The walls take a fixed amount of plastic set by the surface area, so a thin, flat part is nearly all wall, and a chunky cube is mostly infill.
Infill. 20% is right for most parts. 40–60% for parts under load. 100% only when it truly has to be solid, since it adds weight, cost and time fast.
Material rate. Each plastic has its own price per gram. Here's what this shop charges:
| Material | Per gram | Density |
|---|---|---|
| PLA | $0.15 | 1.24 g/cm³ |
| PETG | $0.18 | 1.27 g/cm³ |
| ASA | $0.22 | 1.07 g/cm³ |
| TPU 95A | $0.28 | 1.21 g/cm³ |
| Nylon CF | $0.50 | 1.15 g/cm³ |
Machine time. The printer runs for hours and wears parts while it does. Slow materials such as TPU take longer per gram.
Setup. Checking the file, choosing orientation, slicing, clearing the plate. It happens once per job, which is why a single tiny part costs more per piece than ten of them.
Quantity breaks. 10% off the per-part price from 10 pieces, 20% from 50, because the setup is shared and the plates get packed full.
Worked examples
Calculated with the current rates above.
| Job | Grams | Hours | Price |
|---|---|---|---|
| Dishwasher rack clip, PETG | 3 g | 0.4 h | $35 |
| Shelf bracket 80 mm, ASA, 40% infill | 19 g | 1.5 h | $36 |
| Cable clip, PETG, batch of 50 | 95 g | 16.8 h | $141 ($2.83 ea) |
| Phone-mount pad, TPU, pair | 10 g | 1.8 h | $37 ($18.49 ea) |
What the formula doesn't cover
- Modeling. No file? The part gets measured and drawn in CAD at $75 / hour, from $75 for a simple clip or knob. You approve the modeling price before any work starts, and the finished file is kept, so a reprint later costs only the print.
- Rush. Jumping the queue adds +50%.
- Finishing. Sanding, priming, painting, heat-set inserts.
- Supports. Overhangs need support material, which adds some plastic and cleanup. The firm quote accounts for it.
- Shipping, when you're not picking up.
How to make your part cheaper
- Lower the infill if the part isn't load-bearing.
- Hollow out thick solid sections in CAD.
- Use PETG instead of nylon unless you really need the stiffness.
- Order the spares now. The setup is shared.
How much does it cost to 3D print something?
How much does it cost to 3D print a small part?
Here, a single small part such as a clip, knob or bracket usually lands at the $35 minimum order. That covers the $20 setup, the plastic and the machine time. The plastic itself is often under a dollar; the setup and the hours are what you pay for.
How much does 3D printing cost per hour?
Machine time here is $8.00 / hour. How long a part takes depends on its volume and how fine the layers are, not just its outside size.
How much does 3D printing cost per gram?
It depends on the plastic. The per-gram rates are in the table above, from PLA at the low end to carbon-fibre nylon at the top.
Is it cheaper to 3D print or to buy the part?
If the part is sold off the shelf for a few dollars, buy it. Printing wins when the part is discontinued, only sold as part of an expensive assembly, or doesn't exist yet.