How hot a parked car really gets
A 2018 Arizona State University study parked cars in the Phoenix summer sun for an hour and measured the surfaces. The dashboards averaged about 157°F, steering wheels about 127°F and seats about 123°F. Central Florida runs cooler in air temperature than Phoenix, but the sun is the same and the humidity doesn't help, so plan for the top of a dash to pass 150°F any summer afternoon. Parts in shade, down low or inside a console stay a lot cooler.
What "softens" means for a printed part
Printing plastics don't melt into a puddle in a car. They hit their glass transition temperature, where they go from rigid to rubbery, and then gravity and any load on the part do the rest. A gauge pod sags, a phone mount droops, a clip loses its grip and pops off. The numbers below are glass transition temperatures. A part under load (a spring clip, a mount holding weight) starts to creep a little below them, so leave a margin.
| Material | Softens around | In a car |
|---|---|---|
| PLA | 130–140°F (55–60°C) | No. Fine at your desk, ruined after one summer afternoon on a dash. |
| PETG | ~175°F (80°C) | Yes for most of the cabin: cupholders, consoles, door pockets, clips and mounts out of direct sun. |
| ASA | ~210°F (100°C) | Top of the dash, A-pillars, behind glass, outside the car. Also holds up to UV, which yellows and weakens the others. |
| ABS | ~220°F (105°C) | Takes the heat like ASA but chalks and yellows in sunlight. Good inside, worse than ASA outside. |
| TPU | Stays flexible | Grommets, pads, bumpers, anything that should bend. Handles cabin heat fine. |
Which material goes where
- Top of the dash, in front of the gauges, under the windshield: ASA. This is the hottest spot in the car and it gets direct UV.
- Center console, cupholders, door pockets: PETG. Shaded most of the day and well under its limit.
- Visor clips and headrest hooks: PETG. The visor gets warm but it's out of the direct sun most of the time.
- Under the dash (wire clips, switch panels): PETG.
- Anything outside the car: ASA, no exceptions.
Tips that make any printed car part last longer
- Black parts run hotter in the sun than light ones. It's worth it for the look inside the car, but on a sun-baked dash it's one more reason for ASA.
- Thicker walls hold up better than more infill. Four walls beat 60% infill for a mount that has to stay stiff.
- Use a sunshade. It drops dash temperatures a lot and helps the factory plastic as much as the printed parts.
- Avoid sharp inside corners on clips. Heat plus a constant spring load concentrates right there, so a small fillet keeps them from cracking.
What the car parts here are printed in
Everything in the car section ships in PETG by default. The gauge pods can be printed in ASA when they sit on top of the dash; ask for it in the order notes.
Car52 mm gauge podFits any 52 mm (2-1/16 in) gauge
CarCupholder catch-allFits round cupholders about 66 to 80 mm across
CarVisor clip for a garage remoteFits sun visors about 18 to 30 mm thick; remotes up to about 60 mm wide
CarHeadrest hooks, pairFits headrest posts about 11 to 15 mm thick